Home

Cobalt HD Reel

Cobalt HD Reel

€ 899,00

A bolt from the blue, Cobalt is a big game powerhouse of a reel packed with technical breakthroughs that’ll change the game when fly fishing for salmon or charting the flats. Cobalt features a dual-axis machined frame that dramatically strengthens the side that bears the most load. The foot is embedded—rather than perched—atop the reel to effectively transmit force and distribute weight. The large arbor spool is also machined with many subtle asymmetries that bring perfect balance without a counterweight.

  • Format: Large Arbor
  • Materials: Machined Aluminum, stainless steel
  • Finish: Micralox
  • Weight: 170g g / 8 wt
Article #:N/A
Availability:Yes

Share:

Item Diameter Width Weight Rod wt Line capacity
Cobalt HD 8 108mm 25mm 170gr WF8 250 yds 20#
Cobalt HD 10 115mm 27mm 301gr WF10 250 yds 30#
Cobalt HD 12 121mm 32mm 323gr WF12 250 yds 30#

  1. Do not remove the drag knob or the two-holed nut in the center of the drag knob for any reason.

  2. Always ensure the Gland Cap is tight, especially before using the reel the first time or after reversing the retrieve direction. Be sure to periodically check that the cap is on securely; it should always be firmly tightened by hand, do not use a tool. The Gland Cap should seat completely on the drag cylinder when installed properly.

  3. The drag system is meant to operate lubrication free. Do not use any type of oil or lubricant in or around the drag system. A small amount of WD-40 may be applied to the retrieve handle in order to remove any dirt build up between the handle and the handle shaft.

  4. Freshwater Use: Occasionally rinse your reel thoroughly under fresh running water and wipe the spool and frame to remove any debris or dirt build up. Be sure to wipe down the spindle on the spool and keep it free of debris.

Saltwater Use:

Be sure to rinse the reel under fresh running water after every use in a salt environment. Occasionally rinse the drag by doing the following:

  1. Remove the spool, unscrew the gland cap and remove the red and silver clutch assembly.

  2. Rinse all components including the inside of the drag cylinder thoroughly with fresh running water.

  3. Allow all components to dry completely before reassembly.