Home

Remix HD 3-Pack

Remix HD 3-Pack

€ 329,00

Remix marries the best of pressure cast technologies and CNC machining to deliver a durable frame in a hard
bright finish coupled with a cast aluminum spool with u-shaped arbor. Remix shares the same drag technology as
all of our more expensive reels.

Remix HD is the Heavy Duty spey and switch variant of Remix, incorporating a full cage design to capture thin
diameter running lines that are notorious for escaping through spool/line guard gaps. Majority U.S. manufactured
and assembled in Boise, Idaho.

  • format: Large Arbor, Full Frame
  • materials: Machined 6061 Aluminum Case, Pressure Cast Aluminum Spool
  • finish: Type II Anodize Case, Polyurethane Spool
  • drag: Sealed Conical Drag
  • 80% US Manufactured, 100% Idaho Built
Article #:N/A
Availability: Yes
Categories:  WW-L , WW-L LAMSON REMIX HD

Share:

Item Diameter Width Weight Rod wt Line capacity
Remix HD -7+ 101mm 29mm 181gr WF 6-8 WF8 200 yds 20#
Remix HD -9+ 121mm 38mm 235gr WF 8-10 WF10 250 yds 30#

  1. Do not remove the drag knob or the two-holed nut in the center of the drag knob for any reason.

  2. Always ensure the Gland Cap is tight, especially before using the reel the first time or after reversing the retrieve direction. Be sure to periodically check that the cap is on securely; it should always be firmly tightened by hand, do not use a tool. The Gland Cap should seat completely on the drag cylinder when installed properly.

  3. The drag system is meant to operate lubrication free. Do not use any type of oil or lubricant in or around the drag system. A small amount of WD-40 may be applied to the retrieve handle in order to remove any dirt build up between the handle and the handle shaft.

  4. Freshwater Use: Occasionally rinse your reel thoroughly under fresh running water and wipe the spool and frame to remove any debris or dirt build up. Be sure to wipe down the spindle on the spool and keep it free of debris.

Saltwater Use:

Be sure to rinse the reel under fresh running water after every use in a salt environment. Occasionally rinse the drag by doing the following:

  1. Remove the spool, unscrew the gland cap and remove the red and silver clutch assembly.

  2. Rinse all components including the inside of the drag cylinder thoroughly with fresh running water.

  3. Allow all components to dry completely before reassembly.

You May Also Like